Quick guide how to install driver for arduino boards UNO/MEGA/NANO

Installing driver for Arduino boards

Hello Friends

In this post i will show you how to add Driver for Arduino board like Arduino Mega / UNO / NANO

If you have purchased new Arduino board and going to start your first project using arduino

the first place your where stuck is driver for you board, there are plenty of drivers are available on net

but it need you to be very informative to select proper driver for your board as well as suitable for your operation system.

 

Basically Arduno boards driver are Serial/UART to USB converter driver , A UART is usually an individual (or part of an) integrated circuit (IC) used for serial communications over a computer or peripheral device serial port.UARTs are now commonly included in microcontrollers.

Watch this video to know how to add driver for Arduino boards

Quick guide how to install driver for arduino boards UNO/MEGA/NANO

 

 

Download link

 

Click here to download Driver for Arduino MEGA/UNO Board

  1. Download the file as per your operating system from the above link
  2. Unzip the downloaded file
  3. Run the ”CP210xVCPInstaller_x64″ if you have 64bit processor or run “CP210xVCPInstaller_x86” if you have 32bit processor
  4. It’s done drivers are installed
  5. This driver is works for both Arduino MEGA as well as Arduino UNO Board

 

 

Click here to download Driver for Arduino NANO Board

  1. Download the file as per your operating system from the above link
  2. Unzip the downloaded file
  3. Open the folder “CH341SER”
  4. Double click on “SETUP” file
  5. Click on “YES”
  6. Finally click on “INSTALL”
  7. It’s done drivers is install for Arduino NANO Board

 

sandeep

Hobbiest Electrical DIY project passionate

Leave a Reply